The 1960 may have been made by Daewoo (Korea) or a Taiwan company, or may be an OEMed Panasonic Panasync. The tube is made by Hitachi. There has been some debate over whether it is a true multisync or a trisync monitor. Reports have been provided that indicate it can handle Super72 screen modes at about 23 kHz, and the manual says it can sync up to 38 kHz. It may be a sort of hybrid, with a wide "window" in the 15.75 kHz to 31.5 kHz range.
Common Problems
One common problem involves a component that is insulated with eletrical tape (inadequately) from the factory, resulting in arcing. Replacing this insulation can cure the problem.
Typical failures also result from cold solder joints on the 1960 boards, which can be repaired by resoldering. Additionally, some solder joints (such as those on the flyback transformer) tend to go bad with age. Resoldering them may cure arcing problems.
The screen size adjustment pots may be prone to failure, making adjustments difficult.
Specifications
Sync Frequency: 15 kHz to 38 kHz Horizontal
50 Hz to 87 Hz Vertical
Dot Pitch: 0.29 mm or .31 mm
Input Connectors: HDD15 (Analog RGB), DB9 (Digital RGB; some 1960s may
not have this connector.)
Pin-Outs (HDD15 Analog RGB)
Pin 1: Red
Pin 2: Green
Pin 3: Blue
Pin 4: Monitor Sense, Ground to Pin 10
Pin 5: Ground
Pin 6: Red Ground
Pin 7: Green Ground
Pin 8: Blue Ground
Pin 9: Unused
Pin 10: Digital Ground
Pin 11: Jumper to Pin 10
Pin 12: Unused
Pin 13: Horizontal Sync
Pin 14: Vertical Sync
Pin 15: Jumper to Pin 10
Pin-Outs (DB9 Digital RGB) (EGA?)
Pin 1: Ground
Pin 2: Red Prime
Pin 3: Red Video
Pin 4: Green Video
Pin 5: Blue Video
Pin 6: Green Prime
Pin 7: Blue Prime
Pin 8: Horizontal Sync
Pin 9: Vertical Sync